diff --git a/README.md b/README.md
index e011c2d..a1935cd 100644
--- a/README.md
+++ b/README.md
@@ -1,5 +1,5 @@
 # FreeCAD 2026 Design Contest
-This is my entry to the (2026 FreeCAD design contest)[https://forum.freecad.org/viewtopic.php?t=105082].
+This is my entry to the [2026 FreeCAD design contest](https://forum.freecad.org/viewtopic.php?t=105082).
 For assembly instructions see the assembly guide.
 
 ## Initial Design Choices
@@ -49,7 +49,7 @@ and youd be left with with 60 dowel pins ("worth" 5.80€) and 875g of PETG (wor
 I think a fair cost assesment is somewhere inbetween the two, since most people will have some filament, and so the 6.60€ per valve of filament are a bit over the top. I think the average maker would probably spend around 5-6€ per valve.
 
 ## Performance Assesment/Concerns/Room for improvement
-I have not had the opportunity to test maximum holding and closing pressure, nor how many close/open cycles it can handle. I hope to get around to running those tests in the final week before the submission deadline. (The only test I've managed so far)[https://chaos.social/@la/116727325081926518] was me blowing into the tube with the other end in a glass of water, to see if it closes and seals agains my lung pressure. 
+I have not had the opportunity to test maximum holding and closing pressure, nor how many close/open cycles it can handle. I hope to get around to running those tests in the final week before the submission deadline. [The only test I've managed so far](https://chaos.social/@la/116727325081926518) was me blowing into the tube with the other end in a glass of water, to see if it closes and seals agains my lung pressure. 
 
 I am particularly concerened with the requirement in the contest brief, requireing gas sealing at 0.5bar, and wear resistance.